Specifications
- Brand
- Mobil (ExxonMobil)
- Category
- Process & white oils
- Manufacturer code
- 20156050F0B0
- Availability
- On order
Manufacturer's description
Mobilsol PM is a highly detergent and dispersant synthetic fluid designed to be added to the oil in hydraulic, paper machine or general circulation systems. It releases and holds in suspension gummy oil oxidation products and insoluble materials, enabling efficient clean-up of deposits accumulated over time in reservoirs and pipework, and helping restore the system's original operating efficiency and equipment protection. It is recommended for cleaning oil circulation systems in service, including paper machine lubrication systems, hydraulic systems, open heating systems operating below 140 degrees C, and general circulation systems lubricating gears and bearings, as well as for cleaning machine parts, gears and bearings by brush or dip. Mobilsol PM is introduced progressively in 1% increments up to a maximum of 4% of system volume, circulated for 3 to 10 working days while filters are monitored, then the system is drained hot, flushed and refilled with fresh oil; blending calculations may be needed where a maximum viscosity limit applies, and the product should not be used in NC machine tools or servo valve systems without special engineering consideration. Key benefits include a higher flash point than light petroleum-based solvents (allowing use without shutting the system down), freedom from corrosive materials with limited effect on seals, high detergency that removes foreign deposits, carbonaceous material and sludge, and high dispersancy that holds contamination in suspension for removal by filtration.
Applications
- Mobilsol PM should be used in accordance with the following instructions or recommendation should be sought from Mobil technical service: Introduce Mobilsol PM into a contaminated system progressively in 1% increments based on the total volume of system, (maximum to be used 4%). Circulate dirty lubricant / Mobilsol PM mixture for 3-10 working days whilst regularly checking the condition of all filters. Additional filtration equipment may be required when proper operation of the system could be affected by the release of high amounts of deposits. Oil condition monitoring can be of assistance to monitor the level of deposits being picked up in the oil. Drain the system whilst hot and flush with a small volume (10% of the system volume or less) of the new product being introduced. Replace all filters and cartridges etc. and fill up with the new circulation oil. Where pump or bearing manufacturers specify a maximum viscosity for a particular operation, the change in viscosity caused by the addition of Mobilsol PM should be calculated from blending tables. In some cases it may be necessary to blend Mobilsol PM with a lower viscosity oil before adding it to the fluid in use. Note: Do not use Mobilsol PM in N C machine tools or servo valve systems without special engineering consideration. In any systems incorporating sensitive servo control valves even very small particles of dirt introduced with the solvent/fluid mixture or dislodged by it may interfere with the valve operation. Cleaning hydraulic systems incorporating servo valves must be carried out strictly in accordance with the manufacturers' instructions. Mobilsol PM is recommended for use for the following applications: Clean up of oil circulation systems in service: paper machine lubrication systems, hydraulic system
Performance & benefits
- High level of dispersancyHolds contamination in suspension to assist removal in filters Clean up of circulation systems contributes in improving operating efficiency and prolonging equipment life
Complete documentation
We email you the sheets listed below in a single archive. No account, no order required.
- SDS
- SDS
- TDS